Category: Troubleshooting

How to Enter DFU Mode on iPad Pro (2018 and Later) | Win2Key

Sometimes iPad Pro should be set to DFU mode for troubleshooting before restoring iPad Pro. DFU means “Upgrading Device Firmware”, and DFU mode is a device recovery state that is lower than normal recovery mode for iPad Pro. Turning iPad Pro into DFU mode is intended for advanced users and for special troubleshooting scenarios when

How to Fix iPad Stuck on Apple Logo Screen | Win2Key

In rare cases, the iPad may get stuck on the Apple logo screen when the device boots up or reboots. Jams on the Apple logo usually occur during a software update failure, regardless of whether it was interrupted or incomplete, but sometimes it can happen during recovery, as well as during other operations. If the

Newly Setup iPad Pro Battery Draining Rapidly? “Ongoing Restore” Might Be Why! | Win2Key

If you recently installed a new iPad Pro, iPad mini or iPad and found that the battery runs out unusually quickly, which leads to a decrease in battery life on the device, do not worry, perhaps there is a good reason for this. In fact, if during the recent installation or restoration of the iPad

How to Fix Unzip Error “End-of-central-directory signature not found” | Win2Key

In rare cases, you can try to unzip the zip archive and encounter an error that says “The signature of the end of the central catalog was not found. Either this file is not a zip-file, or it is a single disk from a multiple-part archive. In the latter case, the central directory and zipfile

How to Stop an iCloud Restore on iPhone & iPad | Win2Key

ICloud backup recovery can be stopped at any time on new iOS devices. This means that if you decide to restore your iPhone, iPad or iPod touch from an iCloud backup, either when setting up a device with a previous iOS backup, or to restore a problem device as a troubleshooting method, you can stop